They would typically know where this is located or guide you through the navigation process. ![]() To find this button, it’s recommended to ask the maintenance department or the engineering department for the access key. However, it’s not always programmed by systems integrators and may not be there at all. This button is commonly found within the “Settings” or “Maintenance Functions” of an HMI application. The easiest way to access the configuration menu is by using the “Go To Config” button. Accessing the Configuration Menu through the “Go To Config” Button We will be exploring two ways through which we can set the IP: the Config button as well as through the boot menu. ![]() This procedure is the same for most HMIs from the PanelView family and should be repeatable as is. Today, we will be looking at how to set the IP address on a PanelView Plus 1000 Terminal. Furthermore, it may be accomplished in several distinct ways which aren’t as obvious as we’d all like them to be. ![]() the procedure isn’t complicated but is tricky for a new Controls Engineer. This procedure needs to take place every single time a new terminal is installed or is migrated to a new subnet. ![]() In order to send data to and from a PanelView Plus HMI Terminal, it’s necessary to configure the IP settings of the said device.
0 Comments
Leave a Reply. |